Looking good so far George. Thank you for the pictorial.
The bubbling on those roofs may be due to soap and water not removing completely the release agent that is used during processing that helps the plastic not stick to the molds. I've been told that they may use spray like WD40 or such on the molds and you have to use something like alcohol to really make sure it is gone. I had some links somewhere to sites explaining this but can't find them. Will check further. Also, I know it must be hard with those bumps, but did you sand the roofs so the primer would have something to grab on to?
The bubbling on those roofs may be due to soap and water not removing completely the release agent that is used during processing that helps the plastic not stick to the molds. I've been told that they may use spray like WD40 or such on the molds and you have to use something like alcohol to really make sure it is gone. I had some links somewhere to sites explaining this but can't find them. Will check further. Also, I know it must be hard with those bumps, but did you sand the roofs so the primer would have something to grab on to?
![[Image: super-smiley-emoticon.gif]](http://www.sherv.net/cm/emo/word/super-smiley-emoticon.gif)
![[-]](https://www.blueplastictracks.org/images/collapse.png)