Why is this not implemented?

20 Replies, 13554 Views
Thread Closed 

IMO Only thing it should be left alone is male connector on A. Old A male connector is better as it stays on but that IMO. New B curves is fine. Only difference is Material. Everything else is same.

Another thing i tried is these new block does fit on old curves slopes. But to be honest they don't look good on any curves slope or layout when using them. Hope plarail keep using risers instead of block.
[-] The following 2 users Like drew5195's post:
  • Super, violater



Users browsing this thread: 1 Guest(s)